Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
753 is disassembled, what preventative maintanence should I do?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 29671" data-attributes="member: 82"><p>I'd ensure all your grease nipples are in good shape and free of grit after blasting.</p><p>Fill the chain case with engine oil, like 20W50. Depending on where you live, the hydraulics can use the same oil, thinner if you live in a colder climate.</p><p>I'd get the radiator cleaned and pressure tested, replace ram seals (they are pretty cheap). Bushings in the bobtach and tilt ram, pins too.</p><p>There isn't a whole lot else i can think of. On my machines i have plans of keeping, if i have them pulled that far down, i do axle bearings and seals, motor carrier bearings and seals too. Replace the pins and bushes. I'm actually going to modify my lift rams to accept bushings so i can replace them when they wear.</p><p>If there is anything i forgot, just yell</p></blockquote><p></p>
[QUOTE="Tazza, post: 29671, member: 82"] I'd ensure all your grease nipples are in good shape and free of grit after blasting. Fill the chain case with engine oil, like 20W50. Depending on where you live, the hydraulics can use the same oil, thinner if you live in a colder climate. I'd get the radiator cleaned and pressure tested, replace ram seals (they are pretty cheap). Bushings in the bobtach and tilt ram, pins too. There isn't a whole lot else i can think of. On my machines i have plans of keeping, if i have them pulled that far down, i do axle bearings and seals, motor carrier bearings and seals too. Replace the pins and bushes. I'm actually going to modify my lift rams to accept bushings so i can replace them when they wear. If there is anything i forgot, just yell [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
753 is disassembled, what preventative maintanence should I do?
Top