Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
751 C with Peugeot Motor (Turn Cam Shaft?)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="FFPK751" data-source="post: 38406" data-attributes="member: 222"><p>Yes Tazza is correct with rotating the engine at a min 2 revolutions. I used a rachet on the left side motor (looking at motor while it is still installed) and very slowly turned the crank shaft. What I feel is a very important note is that the motor should only be turned in one direction, which I believe is clockwise when looking at left side of the motor. I believe that is so the belt has tension when pulling on the fuel injector pump and the valves. I know Tazza and Old Machinists can help you better than I probably could but if you have any questions I maybe able to help also. Just post on this thread because I get notified via E mail that some posted. I check my E mail maybe every one to three days. If you want to correspond quicker, put your E mail on here and I will contact you via another E mail address that I check more often. I have been there so I just want to help. FFPK</p></blockquote><p></p>
[QUOTE="FFPK751, post: 38406, member: 222"] Yes Tazza is correct with rotating the engine at a min 2 revolutions. I used a rachet on the left side motor (looking at motor while it is still installed) and very slowly turned the crank shaft. What I feel is a very important note is that the motor should only be turned in one direction, which I believe is clockwise when looking at left side of the motor. I believe that is so the belt has tension when pulling on the fuel injector pump and the valves. I know Tazza and Old Machinists can help you better than I probably could but if you have any questions I maybe able to help also. Just post on this thread because I get notified via E mail that some posted. I check my E mail maybe every one to three days. If you want to correspond quicker, put your E mail on here and I will contact you via another E mail address that I check more often. I have been there so I just want to help. FFPK [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
751 C with Peugeot Motor (Turn Cam Shaft?)
Top