Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 Rear seal replacement - Help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 16053" data-attributes="member: 82"><p>Bearing Cone 6519925 - LM104949</p><p>Bearing Cup 6519926 - LM104912</p><p>Axle Seal 6513277 - CR541523</p><p>Wear Ring 6558477</p><p>As previously mentioned, i really do recommend buying the seal from Bobcat.</p><p>Now, removing the bolt inside you will need a 1 1/8" ring/open end spanner, i have heard bobcat mechanics using the hydrostats to turn the axles and un-do the bolt, this is your choice. If you don't you will need to crack both oil lines to the motors and plug the hoses, leave the motor end open so you can turn the axle. Use a piece of angle or flat with holes matching the studs, use this as a lever to turn the axle which will in turn un-do the bolt inside, my bar was about 6' long, gave heaps of leverage. When done, plug the ports on the motor.</p></blockquote><p></p>
[QUOTE="Tazza, post: 16053, member: 82"] Bearing Cone 6519925 - LM104949 Bearing Cup 6519926 - LM104912 Axle Seal 6513277 - CR541523 Wear Ring 6558477 As previously mentioned, i really do recommend buying the seal from Bobcat. Now, removing the bolt inside you will need a 1 1/8” ring/open end spanner, i have heard bobcat mechanics using the hydrostats to turn the axles and un-do the bolt, this is your choice. If you don't you will need to crack both oil lines to the motors and plug the hoses, leave the motor end open so you can turn the axle. Use a piece of angle or flat with holes matching the studs, use this as a lever to turn the axle which will in turn un-do the bolt inside, my bar was about 6' long, gave heaps of leverage. When done, plug the ports on the motor. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 Rear seal replacement - Help
Top
