Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 Bobtach (oldstyle) tilt pin and bushings
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Centurion" data-source="post: 35339" data-attributes="member: 1813"><p>Hello Everyone,</p><p>I was using my bobcat the other day, and noticed metal filings coming from the pivot pin and bushings on the bobtach. Further investigation showed a great deal of wear on the pin, and the bushings are all wallered out. There were never any grease fittings on this piece, and because of that, I guess I did not pay enough attention. I have looked in the parts manual, and it is not clear to me if I can get replacement bushings from Bobcat, or do I need to make my own? I have done a search on the forum, but could not find answers to my questions. The pin I can determine the part#, but I am not sure on the weld in bushings. If they do not come with grease fittings, they will have them when I am done so I do not have this problem again. Any help would be greatly appreciated.</p></blockquote><p></p>
[QUOTE="Centurion, post: 35339, member: 1813"] Hello Everyone, I was using my bobcat the other day, and noticed metal filings coming from the pivot pin and bushings on the bobtach. Further investigation showed a great deal of wear on the pin, and the bushings are all wallered out. There were never any grease fittings on this piece, and because of that, I guess I did not pay enough attention. I have looked in the parts manual, and it is not clear to me if I can get replacement bushings from Bobcat, or do I need to make my own? I have done a search on the forum, but could not find answers to my questions. The pin I can determine the part#, but I am not sure on the weld in bushings. If they do not come with grease fittings, they will have them when I am done so I do not have this problem again. Any help would be greatly appreciated. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 Bobtach (oldstyle) tilt pin and bushings
Top
