Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
742 drive coupling assembly
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Dave1234" data-source="post: 133159" data-attributes="member: 23099"><p>On my 742B I found that if I got the engine rotated just right, I could see at least one zerk with them positioned on the left side of the machine (that's the left when sitting in the seat, but right when laying on your stomach facing the rear/ engine) at roughly 2 o'clock position when looking towards the rear of the machine. I could only see it with one eye, the other eye was blocked, but it was easier to clean them and to attach a locking grease gun end onto all three in that position than with them rotated to the other side where I could see nothing. I marked the engine crank pulley and outer shroud with match lines so I could turn it to the right place the next time.</p></blockquote><p></p>
[QUOTE="Dave1234, post: 133159, member: 23099"] On my 742B I found that if I got the engine rotated just right, I could see at least one zerk with them positioned on the left side of the machine (that's the left when sitting in the seat, but right when laying on your stomach facing the rear/ engine) at roughly 2 o'clock position when looking towards the rear of the machine. I could only see it with one eye, the other eye was blocked, but it was easier to clean them and to attach a locking grease gun end onto all three in that position than with them rotated to the other side where I could see nothing. I marked the engine crank pulley and outer shroud with match lines so I could turn it to the right place the next time. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
742 drive coupling assembly
Top