Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 rough running, backfiring
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="GILL" data-source="post: 68726" data-attributes="member: 265"><p>I have now drained the fuel tank by letting fuel run out of hose that is before fuel pump. If you turn on switch the fuel runs out unobstructed. I took top off of fuel pump and it seems fine by me and a NAPA guy. It's been reinstalled. The little filter that is inside pump only had a few specks on it. The pump arm was fine and I turned engine over while keeping my finger on the lobe that drives the pump. There was no groove or flat spots or burrs felt. I've also turned the timing mark to TDC and the rotor points at #1 cylinder. The lawn and garden store next to NAPA is getting me a gasket kit from the outfit that makes the carb rebuild kit. While waiting for it I will pull the tank and see if it needs cleaning. I also pulled the seat and pan to see if there was a wire rubbing on something that would ground out the fuel solenoids. I'll post more when I know more. Greg</p></blockquote><p></p>
[QUOTE="GILL, post: 68726, member: 265"] I have now drained the fuel tank by letting fuel run out of hose that is before fuel pump. If you turn on switch the fuel runs out unobstructed. I took top off of fuel pump and it seems fine by me and a NAPA guy. It's been reinstalled. The little filter that is inside pump only had a few specks on it. The pump arm was fine and I turned engine over while keeping my finger on the lobe that drives the pump. There was no groove or flat spots or burrs felt. I've also turned the timing mark to TDC and the rotor points at #1 cylinder. The lawn and garden store next to NAPA is getting me a gasket kit from the outfit that makes the carb rebuild kit. While waiting for it I will pull the tank and see if it needs cleaning. I also pulled the seat and pan to see if there was a wire rubbing on something that would ground out the fuel solenoids. I'll post more when I know more. Greg [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 rough running, backfiring
Top