Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 rough running, backfiring
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="GILL" data-source="post: 68624" data-attributes="member: 265"><p>I have not checked for fuel ahead of pump since it pumped fuel while turning it over easily enough with switch on. Fuel seemed to run through pump when key was on, and motor not being turned over, enough to keep end of hose in can. I did find the carb was a little loose where it attached to manifold and I tightened it up the other day. I have not checked for vacuum while engine is running, it usually won't run long enough to get everything hooked up. The funny thing is it started easily after sitting since Wednesday night but after a minute or so it just acts like it's out of gas. I thought of pulling tank and trying to see inside but, I'm not sure that you can. I'll have to look again in the book to see it that's possible. I have not looked at valve adjustment. Not sure I want to go there. I'll keep trying, Greg</p></blockquote><p></p>
[QUOTE="GILL, post: 68624, member: 265"] I have not checked for fuel ahead of pump since it pumped fuel while turning it over easily enough with switch on. Fuel seemed to run through pump when key was on, and motor not being turned over, enough to keep end of hose in can. I did find the carb was a little loose where it attached to manifold and I tightened it up the other day. I have not checked for vacuum while engine is running, it usually won't run long enough to get everything hooked up. The funny thing is it started easily after sitting since Wednesday night but after a minute or so it just acts like it's out of gas. I thought of pulling tank and trying to see inside but, I'm not sure that you can. I'll have to look again in the book to see it that's possible. I have not looked at valve adjustment. Not sure I want to go there. I'll keep trying, Greg [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 rough running, backfiring
Top