Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
642B steering help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 4172" data-attributes="member: 82"><p>I'm at work at the moment, i can take a picture of the pake in my manual that shows the poppets.</p><p>It may not be junk stuck in it, it may have worn so it doesn't create a good seal any more. Either way, if you look at your hydro pump, where the 2 fat hoses join on each side you will notice i think 2 large bolt heads, say 1-1 1/2". Behind here are springs and poppets. One side is for your charge oil, the other is relief, the problems is i can't remember which side is which. If you remove the plugs, do make sure you replace the O rings, there is up to 5,000 PSI behind these. You don't want them to leak.</p><p>Make sure you don't mix the springs up! only do one side at a time and you will be fine. The springs should be colour coded, this just indicates what the relief pressure is set to.</p><p>I will do my best to remember to take a pic of the page needed.</p></blockquote><p></p>
[QUOTE="Tazza, post: 4172, member: 82"] I'm at work at the moment, i can take a picture of the pake in my manual that shows the poppets. It may not be junk stuck in it, it may have worn so it doesn't create a good seal any more. Either way, if you look at your hydro pump, where the 2 fat hoses join on each side you will notice i think 2 large bolt heads, say 1-1 1/2”. Behind here are springs and poppets. One side is for your charge oil, the other is relief, the problems is i can't remember which side is which. If you remove the plugs, do make sure you replace the O rings, there is up to 5,000 PSI behind these. You don't want them to leak. Make sure you don't mix the springs up! only do one side at a time and you will be fine. The springs should be colour coded, this just indicates what the relief pressure is set to. I will do my best to remember to take a pic of the page needed. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
642B steering help
Top