Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
642 Hydraulic Pump replacement (Vickers part number)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 3781" data-attributes="member: 82"><p>I think it is a v20 series, but the internals look the same. The PDF was just for a guide so you know whats inside.</p><p>Usually the pump has the model number stamped on the casting. It will detail the series, GPM flow rate, mounting arrangement etc.</p><p>As for bearings, i really don't know if they will be in the kit, but i would suspect they would be. I have replaced them in a V20 series pump before, they were just common bearings so they were nice and cheap and easy to find.</p><p>If you are able, i would take the pump off and take it to your local vickers/eaton dealer and get them to identify it for you, that way you know you got the exact rite part. Just remember when you remove the pump, you will loose heaps of oil. You will need a new O ring for the mounting of the pump to the hydrostatic pumps. Drain as much hydro oil as you can before removing it.</p><p>Good luck with it all. Let us know how you go.</p></blockquote><p></p>
[QUOTE="Tazza, post: 3781, member: 82"] I think it is a v20 series, but the internals look the same. The PDF was just for a guide so you know whats inside. Usually the pump has the model number stamped on the casting. It will detail the series, GPM flow rate, mounting arrangement etc. As for bearings, i really don't know if they will be in the kit, but i would suspect they would be. I have replaced them in a V20 series pump before, they were just common bearings so they were nice and cheap and easy to find. If you are able, i would take the pump off and take it to your local vickers/eaton dealer and get them to identify it for you, that way you know you got the exact rite part. Just remember when you remove the pump, you will loose heaps of oil. You will need a new O ring for the mounting of the pump to the hydrostatic pumps. Drain as much hydro oil as you can before removing it. Good luck with it all. Let us know how you go. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
642 Hydraulic Pump replacement (Vickers part number)
Top