Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
632 has LOUD noise and no movement
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jerry" data-source="post: 9375" data-attributes="member: 931"><p>Bob, it is a double u-joint in there with a center piece between. I changed mine on the 632 this summer, it takes a couple hours to pull the engine and about the same back in. The u-joints were available from the Bumper to Bumper auto parts store but they grease down in the cross and not in the end cap like the original and they were only like $10 cheaper. From Bobcat they were $153 for both and $13 for new bolts. Hopefully it didn't hurt anything else in there like the fan on the flywheel. By the way Bobcat quoted about $1000 to do the job but I think they were going to replace the center piece also. The coupling is held on the pump by a center bolt and is a tapered fit be sure it tightens down on the taper. On mine it did not until I made a washer to put under the bolt head but the previous owner had the joints break so that may have had something to do with it.</p></blockquote><p></p>
[QUOTE="jerry, post: 9375, member: 931"] Bob, it is a double u-joint in there with a center piece between. I changed mine on the 632 this summer, it takes a couple hours to pull the engine and about the same back in. The u-joints were available from the Bumper to Bumper auto parts store but they grease down in the cross and not in the end cap like the original and they were only like $10 cheaper. From Bobcat they were $153 for both and $13 for new bolts. Hopefully it didn't hurt anything else in there like the fan on the flywheel. By the way Bobcat quoted about $1000 to do the job but I think they were going to replace the center piece also. The coupling is held on the pump by a center bolt and is a tapered fit be sure it tightens down on the taper. On mine it did not until I made a washer to put under the bolt head but the previous owner had the joints break so that may have had something to do with it. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
632 has LOUD noise and no movement
Top