Reply to thread

Message: <blockquote data-quote="7LBSSMALLIE" data-source="post: 78445" data-attributes="member: 6879"><p>now you did run youre flow check spec says 20? youre getting 15 that is 75% of pump flow spec says 85% min I would catch it now before pump grenades into sys. assumption being that if you now how to a flow test you were smart enough to a direct pump test? haven't seen a 341 in awhile if memory serves its a trip stack. and running attach the way you do failure would not surprise. my advice do a direct pump check on all three. if flow is withen at least 85% (spec not gospel) tear down suspect pump. inspect repair or replace as needed. also why youre in there. doing flow and pressure checks. dial up all reliefs to hi side of spec. this is what I refer to as a hyd tune up. 150 psi on reliefes transmits a major difference at the sticks. good luck finding indv. parts for pumps. I know they are out there? but havening done this a time or three. seal kit aint going to do jack.</p></blockquote><p></p>