Reply to thread

Message: <blockquote data-quote="SkidsDeereMech" data-source="post: 68371" data-attributes="member: 9690"><p>If this unit has no foot throttle, remove the foot well and on the operators right side under the foot control there will be a bag with a connector in it. Make sure there is no water in the connector. Two other locations to check for water are on the wiring harness beside the ECU "with the cab raised" there are two connectors there. One is a four pin weather pac and the other is a three pin make sure there is no moisture inside these.These connectors should just be capped they are the connectoin points for the remote start diagnostic box. The final and most commen problem place is the connection for the fuel pump solenoids on the rear rhs of the engine I'm pretty sure it is an 8 pin deutsch connector push the tab down and pull the connector out inspect for moisture. I hope this is clear enough and helps. When I say inspect for moisture I actually mean blow out the connector with compressed air.</p></blockquote><p></p>