2010 bobcat s150 error M4304

[clydesdale]

I went to start my skid steer and I received this code, M4304. It appears to be a communication error with the panel. But, I could still hit the start button and it started and then stalled. I then went to start it again and it did not have the code. I used the machine for a bit and then let it sit for a couple hours. When I went to start it, it behaved the same way. Any idea how to solve this? Thanks.

 

[flyerdan]

A quick whip around on the web found a possible solution as that code doesn't show up in the listings.
Found this on JustAnswer, original thread here.

.This is a communication code with the display panel. Possible causes are going to be the connection on the back of the panel is not connected well or pins are dirty and not making good connection or the pins are backing out of the connector or the faulty controller. If the wires and connector check out fine then it needs to go to bobcat for the repair since the controller requires programming...