Reply to thread

Message: <blockquote data-quote="Fishfiles" data-source="post: 19794" data-attributes="member: 782"><p>tyan707 .sorry for the late reply , been out of town for the holiday and just returned , yes thats the coil which controlls the hydraulic lock on the tilt and boom , you can test it off the machine by hooking it to 12 volts and putting a metal rod such as a screw driver thru it , it should magnetize and pull the driver to it's sides of the hole , , the stem which it sits on could be sticking if the coil test ok , you can remove the stem from the valve and put the coil over it , apply voltage and you can see and hear it pop , you could have a problem with the wiring going to the coil , where the cross bar goes across the chain case to the controll vavle is a spot where I have seen it wear into th wiring , it may not be getting a signal (voltage) from the controller , another thing I have seen is the insulation on the wires gets broke off right where the wires go into the coil and may be shorting there</p></blockquote><p></p>