Reply to thread

Message: <blockquote data-quote="Centexequipment" data-source="post: 135683" data-attributes="member: 24288"><p>I would start with the seat belt sensor. See if there is a connection issue. Also check the seat and lap bar make sure if there is sensors on those that the connections are good and clean no pushed back pins or broken wires. There are spool locks on the valve so you could check to make sure you're getting power to those. They should be on the same circuit together. If you have power there you then need to check the ground circuit if you have good connection to ground at both connectors then look at the solenoids. If I remember correctly they should ohm out at around 10 ohms</p></blockquote><p></p>