Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
2005 Bobcat 773g fuel shutoff solenoid
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Feedbag" data-source="post: 120422" data-attributes="member: 16996"><p>Hi, was wondering if someone could explain an issue I'm not understanding on my Bobcat 773 fuel solenoid. On wire 8800, which is the "hold" wire, with the ignition key turned to the on position, but without the engine running, I measure a little over 5 volts, which is normal as far as I know. Wire 8100, which is the "pull" wire, measures 0 volts, which is normal as well. The 2800 wire is the ground wire. Now, when I start the engine and while it's running, the 8800 hold wire then reads about 13 volts.... This is what I am not understanding. I know the pull wire will energize and provide 12 volts to initially pull the fuel shutoff valve open, but then drop out leaving the hold voltage wire to keep the valve open at about 5 volts. But the voltage on the the 8800 hold wire stays at around 12 volts when I believe it should be reading around 5 volts... I'm confused, can anyone shed some light on this and educate me? It would be appreciated.... Thanks - Greg</p></blockquote><p></p>
[QUOTE="Feedbag, post: 120422, member: 16996"] Hi, was wondering if someone could explain an issue I'm not understanding on my Bobcat 773 fuel solenoid. On wire 8800, which is the "hold" wire, with the ignition key turned to the on position, but without the engine running, I measure a little over 5 volts, which is normal as far as I know. Wire 8100, which is the "pull" wire, measures 0 volts, which is normal as well. The 2800 wire is the ground wire. Now, when I start the engine and while it's running, the 8800 hold wire then reads about 13 volts.... This is what I am not understanding. I know the pull wire will energize and provide 12 volts to initially pull the fuel shutoff valve open, but then drop out leaving the hold voltage wire to keep the valve open at about 5 volts. But the voltage on the the 8800 hold wire stays at around 12 volts when I believe it should be reading around 5 volts... I'm confused, can anyone shed some light on this and educate me? It would be appreciated.... Thanks - Greg [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
2005 Bobcat 773g fuel shutoff solenoid
Top