2003 773 g

Skidsteer Forum - Bobcat, New Holland, Case, John Deere

Help Support Skidsteer:

As an Amazon Associate we earn from qualifying purchases. Product prices and availability are accurate as of the date/time indicated and are subject to change.
Mouse nest?
I have ran thru the wires several times and have yet to spot any damage. After replacing the sensors the codes have been removed, however the loader locks up and will not move and may show NONE or several other codes
 
I have ran thru the wires several times and have yet to spot any damage. After replacing the sensors the codes have been removed, however the loader locks up and will not move and may show NONE or several other codes
Did you find all of the grounds some are hidden and don't forget the main one off the battery
 
Did you find all of the grounds some are hidden and don't forget the main one off the battery
I'm not sure if i missed any hidden grounds. I did a test with a volt meter,, positive side of the battery positive side of tester negative side of tester to positive feeds and it shows a positive wire grounded. Would a coil or sensor not working create a ground?
 
I'm not sure if i missed any hidden grounds. I did a test with a volt meter,, positive side of the battery positive side of tester negative side of tester to positive feeds and it shows a positive wire grounded. Would a coil or sensor not working create a ground?
Did you find all of the grounds some are hidden and don't forget the main one off the battery Any schematics of the grounds? I have cleaned,sanded and repaired all the grounds around the battery and the 2 behind the seat/cab
 
Did you find all of the grounds some are hidden and don't forget the main one off the battery Any schematics of the grounds? I have cleaned,sanded and repaired all the grounds around the battery and the 2 behind the seat/cab
This is still unresolved,, I checked and cleaned all the grounds i am aware of, replaced the computer,wiring harness and the key switch ( they were badly weathered) all the sensors and now the temperature gauge fluctuates and locks the loader.
 
This is still unresolved,, I checked and cleaned all the grounds i am aware of, replaced the computer,wiring harness and the key switch ( they were badly weathered) all the sensors and now the temperature gauge fluctuates and locks the loader.
Have you tried disconnecting the alternator to just check that it is not over voltage? very odd issue
 

Latest posts

Back
Top