Reply to thread

Message: <blockquote data-quote="Quadordie" data-source="post: 56445" data-attributes="member: 6018">Just got it back together after a complete "frame off" repainting project and I have no lift/tilt. It is hand controls with 1292 hours. The wiring harness appeared in good shape, but I was fighting intermitant lift/tilt issues before taking apart.  Usually, I would shut down or let sit for a minute and fire back up and it worked.  As part of the repaiting project, I cleaned the fuse box/connectors hoping that would cure it.  Was going to try some contact grease to help as well.  But so far, nothing.  It moves forward/reverse fine.  But when I sit in the cab, drop the BICS bar, and push the green operating button, i only get three lights, No lift/tilt.  I have NO CODES.  I have reviwed the grounds, I don't believe I missed one.  Looked at the controller, and the plugs are tight.I should note I don't have the seat installed yet, and the cab is partially completed as I haven't installed the AC/Heat equipment until I have solved the ACS issue.  Is there a ground that is part of the AC/Heat or Cab that might be causing the issue?  I have two grounds on the cab wiring harness that are grounded to the cab.Does anybody have a way to diagnose?  Any tips to find the issue?  I am convinced its electrical, but not sure where to start diagnosing.</blockquote>