Visit our tractor and agricultural equipment communities:

Ingersoll Forum Case IH Forum Combine Forum Hay Forum

JCB Forum John Deere Forum Kubota Forum Mahindra Forum

Massey Ferguson Talk New Holland Forum Valtra Forum Yanmar Forum

Zetor Forum Farming Forum

Reply to thread

Help Support SkidSteer Forum:

Message: <blockquote data-quote="Fishfiles" data-source="post: 5797" data-attributes="member: 782"><p>Some early machines I have stuck the controller from another machine and it will work , some will not and you will have to have it reprogrammed by the dealer as the software to do it is not available to the customer , if it does plug in and work the s/n and hours will be from the machine you took it out of will then be on the machine you put it on , the newer machines don't seem to swop too well , you stand a better chance of a swop working if the machine you took it out of and are putting it into are both plain jane early models , no high flow , no hand controlls , etc , as some functions have to be turned on from the lap top by the dealer , even though on the same model number machine some controllers are 2 plug set ups and some are 4 plug set ups depending on s/n breaks , which makes a replacement find even harder ----- I think you will have to bite the bullet and buy from the dealer as finding one used that will work will be like finding a 1/2 of a needle in a hay stack , you can order the controller preprogrammed for your machine and you just have to stick it in , it is located behind the left panel on side of your left foot sitting in the machine , be sure to disconnect the batterry before making the swop , the new one will probally not line up with the two mounting holes and the tire will have to be removed and one hole will have to be redrilled , $550 isn't too bad , I just changed the controller on a 334 this pass Monday and with the programming fee of $30 and tax it came to $1200, fishfiles</p></blockquote><p></p>

Verification