Reply to thread

Message: <blockquote data-quote="walio123" data-source="post: 70512" data-attributes="member: 9827"><p>First check all fuses. If they are ok check relay.Relay has 4 ports. 1 command that receive commands from the ignition key, or the button,1 graunded and 2 workining. Remove the relay, and look where it enters the base.Looking base hole closest to the clip of the relay is the cable which comes voltage to the spark plugs. Check connections betwin port hole and glow plug bar .If no connection replase cable. Next hole clockwise grounded.Check the connection between this port and the negative battery cable or engine base.If no connection replase cable. Next hole port clockwise is positive constant, between it and the cable that goes to the relay plug makes the connection, when given command / ignition switch or button /.Measure the voltage. If no voltage reading-replase cable.Next hole clockwise is comannd port.To check it, you will need another person. With a cold engine give contact and / or press the heating. Voltmeter should show you 12-14 volts. If not, you need to check the connection between this port and heater switch or ignition key.Ako everything described here is ok , you have to change the relay. Sorry for тхе bad Еnglish language, I hope that was useful to help.</p></blockquote><p></p>