Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
Case Skidsteer Forum
1840 Parking Brake
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Mike12" data-source="post: 56883" data-attributes="member: 5268"><p>Pull out the floor plate locate the rubber boot that goes over where the parking brake pin gets inserted into the sprocket. Disconnect the cable then remove the U shaped pin that the holds the pin assembly in place. Remove the pin asse4mbly and see what needs fixing. Is your brake not releasing ??? Check to make sure the pin that runs to the cable has not backed out of the parking brake pin if it has disassemble clean put back in with red loctice. May take a couple of tries to get the pin in far enough so that it will release properly. Make sure you grease the pin assemble or it will stick and not pop out properly and release the brake. Also if some of the parts are shot on the assembly case has a rebuild kit for around 40 bucks.</p></blockquote><p></p>
[QUOTE="Mike12, post: 56883, member: 5268"] Pull out the floor plate locate the rubber boot that goes over where the parking brake pin gets inserted into the sprocket. Disconnect the cable then remove the U shaped pin that the holds the pin assembly in place. Remove the pin asse4mbly and see what needs fixing. Is your brake not releasing ??? Check to make sure the pin that runs to the cable has not backed out of the parking brake pin if it has disassemble clean put back in with red loctice. May take a couple of tries to get the pin in far enough so that it will release properly. Make sure you grease the pin assemble or it will stick and not pop out properly and release the brake. Also if some of the parts are shot on the assembly case has a rebuild kit for around 40 bucks. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Case Skidsteer Forum
1840 Parking Brake
Top