Hey guys! New to this so sorry if there’s already a thread. Just purchased a case 1816. Rebuilt the carb and it runs like a top. However, when we flip the switch to engage the belts for the pumps, nothing happens. Any ideas? Common problem? Is there something I need to do other than flip the switch to engage the belts?
1816
- Thread starter Jhaycox
- Start date
walio123
Well-known member
- Joined
- Dec 9, 2013
- Messages
- 367
There is an electrical clutch /the pulley of which the three V belts are attached together/. Unplug the socket that came out of it and see if it's 12 Volts in it when swicth is engaged. Take care of the V belts in this procedure so that they do not catch anything and see where and how you will spend the cables to check. If you have 12V it is a clutch problem, if not - it is electrical problem
