Recent content by Yukonr

This has been a b!tch of a job. Cutting the sealant between the sliders and the bottom stationary glass doesn't work either. With the window assembly out, you have to undo the screws holding the frame together (4 at the bottom center) and keep working the frame open (the back side seems the...

Ok, so I got the window frame out of the cab. The gauge/switch pod has to come out, which means the plate across the top of the door jam has to come off but to get at the bolts you have to remove the lights and then you still have to take out the roof glass because the pod won't slip past it...

I had a similar problem with my 01 226. Left it on site overnight and when I came back it was dead. Same as your issue. It ended up being the ground cable from the battery to the back of the engine. It looked all nice and clean and tight (only 1000hr machine), but taking it off and torquing it...

Hi guys, new to the forum other than lurking a few times. I'm stumped. I have a 2001 226 Cat with a factory enclosed cab. I broke the front side slider on the right. So I've got new glass from Cat, but to install it I have to remove the window assembly(front/back sliders and a stationary bottom...