Recent content by wright const

607 bobcat backhoe att. located in Boston ma ,free delivery 75 miles from boston . Best offer Thanks

Why do you want to track one piece of equipment . If your doing it just in case of theft just get a lojack and your insurance co will also give you a discount

Punch holes in the bottom about 16'' x 16'' .I punch about 10 or so, put 3/4 stone around holes with a fabric to keep them from clogging with silt . Knock sides in about 2 ' down and fill away.

I told my wife i dropped a 100 bucks down there , I said while your arm is in there stick this on that grease fitting . Worked once, now she tells me were to stick the grease gun.

Im a little late on reading this post but dirthog are you still looking for a grapple and were are you located, Im just outside Boston and im not a red sox fan. Patriots fan tho . Thanks John

Im with Tazza on this ,Left handed drill bits are the best.

What state you in ?

When your ready let me know which set your selling.I need a set for a S 185 . Thanks John

Here is what i do when you have to drive on,run a chain from the front of your trailer to the rear but over your bob-tach and under the machine (hard to explain i guess) that way when i pops a wheelie the chain stops you from the heart attack.

How long do you plan on keeping the machine ? how much do you want to spend ? I would send it out and have new pistons and rings ,your already gone this far might as well go all the way.

What are you planning on pulling this set up with,I have a 709 backhoe and I put it in my pickup bed .I use a F350 superduty.

Got it found a broken wire

I know this question has been beaten to death but here goes,8 ft fisher wont angle tryed everything I found on this forum .Plow is not binding up ,lines are clear ,hooked up my grapple and it works fine ,flow limiters clear, (even took them off) flat face coulp clear ,when I hit the switch to...

Also fill the filter with fuel first ,it helps with priming the system.

sending