Recent content by Wis XM

I pulled the bronze filter and it looked pretty clean. There was some larger sediment trapped and since I had purchased a new one, I went ahead and replaced it. I had the same problem afterwards so I pulled the temperature sensor and put in one that controls a temperature gauge I mounted in the...

Thanks! The hyd oil cooler looked pretty clean. It will be a couple days before I get the chance to replace the bronze filter in the block. I'll let you know how it goes.

I see a block that has 5 hoses connected to it. 3 on one side, a larger one going back and 1 coming off the front and going down. THe front one is right beside a sender unit. I did not check the oil cooler. Where is it? I'm running Bobcat brand hydraulic oil and I think they would have replaced...

New poster here. I have a early model 743. The Hyd. warning light comes on after 20-30 minutes of running if I have the throttle higher than half-speed. I think it is because of temperature and not pressure because it is not intermittent. It will only go off if I reduce throttle or shut the...