Recent content by vcci

Okay finally I had a Bobcat dealer look at it and was told that the computer is bad. Does this make sense? If so where can I find the computer? The dealer wants $550. Is that reasonable or should it cost less? Thanks

I think the reason for it shutting down is the oil pressure sending unit is bad. As I said before the mechanic checked the pil pressure and said it's fine which leads me to believe that the sending unit is not sending the right information. It always stays running for pretty much the same amount...

I replaced the safety sensor for the bar where it pivots and that didnt take care of the problem. I also cheked all the fuses and sensors and they all seem fine. I checked the codes in the unit and was given codes 4-14, 5-14 and 5-15. They all refer to some sort of either engine pressure or...

okay it's definately s G series as the lights are triangle lights. Where can I find the sensor? I thought it was an F series but I was wrong. I'm sure if I can find the sensor and replace it will take care of the problem. Thanks again.

I think now that you guys mention this seat sensor it makes sense. I can drive it backward and forward but only if I accelerate more on the throttle. Also it does seem to have a hard time to disengage the brake system. When I first bought it I had a hard time getting it to drive because of the...

I just bought a 99 763 that has some sort of electrical problem. After starting and leaving it running for a couple of minutes the thing just turns off. The hydrolics are also not operating for some unknown electrical problem. I had the hydrolic system checked out and was told that it was fine...