Recent content by twinriversmarine

Have 2001ls 180 2 speed and it does not go into high speed. It was working fine then one day I flipped the switch and nothing happened. Any ideas as to what is causing the machine not to engage high speed? it has about 3800 hours on it, everything else on the machine works great.

Thank you for the response and thoughts. You guys are correct I found a crack in one arm and when looking at it the arm is twisted as well. The crack is very small but I assume this is throwing it off. I'm going to take some pictures to show you guys then it will go under the knife. Thanks again...

The high side(right) has been welded previously. I have owned the machine for almost a year it was fine when I bought it, I lift a lot of block pilings and lumber. The tires are fairly new and worn even. I just moved a bunch off ill and now one arm rubs the frame and the other rubs the right...

Is it possible to level the boom arms on a LS 180. The arms are over an inch off, I measured the hydraulic cylinders on both sides at the end of the cab and they are way off. How do you balance the arms to make the bucket/forks/ attachments level? Please help!!

Thanks for the response, I ended up jumping the seat belt wire and the seat switch wire. Now the machine thinks there is always weight on the seat so the seat belt wire can stay jumped.

Hi, I have a 2000 new holland LS180 with 3500 hours on it. The machine runs great but the seat belt light is very finicky. You have to put the belt in a bunch of times to get it to turn off, and today i could not get it to go away so i cannot use the machine. I tried taking apart the push...