Recent content by tractor_man2012

Yes i have power there

Another problem. I replaced all the head light and rear bulbs. The back light are working but the front is not. No power to the plugs. I put all new relays,

Yep that's the same with this machine.

got it, is been working since i replace all the relays. now im trying to figure out the 2 speed. any ideas on that? i flip the switch doesnt seem to do anything

I have it working now. I'm having issues with the hand controls AHC light comes on with code 32-35

Yes. I've swapped relays. I'll dig it to the wiring and see if there's a broken wire or something on the back side

I'm guessing I have major main board problems. B4 this start the (HAC) light would come on

When I turn the key to start the machine it spins over for 1 or 2 seconds and stop (!) Light comes on. Then I tried to jump the solenoid on the start just spins over. And I tried manually with the fuel shut off

I tried that

Picked up a bobcat 873. Ran fine. Got it home now it just turns over for a sec and then stops. Code 14-03 pops up

I have a OMC Mustang 310 left and right reverse works ok, forward only the right side works. No forward on the left side. would that be the pump or the motor?

Wanted: exhaust for Gehl 2600 skidloader

WANTED Hydraulic Drive Motor - RH/LH Bobcat 630 520 530 631 632 MAE24012