Recent content by Topper1

And i prefer the series 3 machines. I pull the side glass every spring for a thorough cleaning and polish. Lasts the season with regular washing. The t3 units are still pre emission for the most part and easy to work on imho. Agree, that much rust on the engine is a definite pass. It's a...

06-2010 models. The starter solenoid contacts burn back just enough to cause the click, click, no turn issue. If the starter / flywheel gears dont mes (tooth on tooth), the solenoid contacts do not make contact. Starter gets no power & ca not turn. Add a thin spacer washer to each starter...

Those are 2.8mm locking delphi metri-pac 280 terminals. 5 wire sizes available from 10AWG to 22AWG Refer to page 4 https://www.swe-check.com.au/catalog/9004.pdf

Theres a lot going on internally with a hydrostst pump. But to put it simply, When cold, oil does not flow as intended. The actuator valve is spring centered but is also internally pressure regulated. The initial startup oil pressure spike pushes the swash plate servo actuators, easily...

I'm with Chris. Add an accessory power relay. Most relays activate with only 1/4 - 1/2 amp. Easy solution. Key turns on relay. Relay powers accessories from FUSED battery connection.

Although I'm unfamiliar with the t300 specifically. Park the unit so filler side is low. You could use a simple sifon hose, or if you have, Fit a fuel transfer pump with a hose suction rather then the solid pipe. Suck the tank dry. Key point is to ensure the filler side is lowest. I generally...

I have had similar issues in the past. Dirty (water in fuel) from gas station, dirty fuel and old fuel from transport tanks and storage tanks. Most diesel treatments have the required additives to handle the potential issues described. Storage and transport tanks should always be fitted with an...

There are alternate suppliers world wide, but https://www.mycnhistore.com/ca/en/newhollandce is a good start. Parts diagrams Parts lists and availability.

I built my own. An hour on the sewing machine, Walmart deck table cover on sale $15, left over foil bubble insulation from a local plumber(free) super magnets from dollar store $5, and some vinyl drawer liner for magnet strips. Water proofed with whatever is cheap. Silicone spray, tent spray...

Thought this may be worth mentioning. Every state, county, province, territory will vary so check with your local authorities.. In some jurisdictions, special licensing, special registrations and insurances are required for towing additional weight in a "commercial enterprise". In my area, we...

If you are going through all the work of adding heat, whether it's electric, diesel or coolant based, the best option in my opinion is always coolant. Least amount of power draw, least chance of fire, and most available on the open market. The cost, work effort & installation time will be...

2007 L185 uses the standard Case/ New Holland temp sensor #A166057 which is a thermistor (temperature variable resistor), NOT a simple on/off temperature switch. The A166057 sensor also applies to upgrade models with gauges for Case & New Holland skid steer models from late 2006 - early 2014...

800 watts would be pulling 67 Amps @ 12 volt. 600 watts +/- 50 amps. That's a lot of consistent juice to pull off a charging system. Ohms law Amps = watts/volts

Trailer brakes are a must, in due diligence, liability and in lawful perspectives. A lot of us have had controllers fail, wiring failures, blown tires, etc and managed to limp home with extreme caution. It always comes down to state of mind in admitting freely that there is an issue, and that...