Recent content by tapline

It could be the issue but so far it has been running ok without going into limp mode. I changed the maf sensor and put in a new primary and secondary filter. I did a thorough cleaning in all the nooks and crevices and keep the intake screen clear of debris and finer solids. I do, on very limited...

Well thought Id have great news but after running flawlessly with a front tiller attached, it did it again after about 40 minutes. Back to the drawing board.

I bought the machine from an auction site and honestly, I think the previous owner must of used it in a dust factory. I have taken out the battery, cleaned behind and in between, and found some air vent openings I cleaned out with a blower. When I lifted the cab, I also checked all the wires...

Thanks for the reply cdmccul. It is surely dusty here and deceiving since the grass is green and lush but about an inch below the roots, you hit nothing but soft dirt and dust. I cleaned out the filter and then decided to replace it with a new one. I also took off the tubes on the right and...

Hello all. I purchased a piece of property in SW Arkansas and started clearing brush, using my skidpro brush cutter. Worked great all day and partly into the next but after about 10 hours of steady use, (I think) the oil pressure warning light came on, or at least that's what I think it is...