Recent content by stew

Thats codes stands for the 8 volt system of the loader is to low. Let me explain this loaders controller cuts down the 12 volts and turns it to 8 volts to only a few senders like engine oil pressure sender, lap bar sender, hyd pressure sender, and engine coolant sender. Its could be any one of...

There should be two ground wire. One goes to the starter, the other one goes to the body of the whole machine. The body ground is the important one for the rest of the electronics. Most engines are rubber mounted so the starter one does not ground very well to the rest of the machine.

hi, new to the forum and had an issue with my AC S turning off the lift and tilt valves. so I went to search these forums. I started with the lift actuator and switched that with the tilt, code stayed the same. Then I started running continuity test on the wiring and found a short to ground on...