the high compression in the cly maybe be due to carbon buildup or if there has been leak mineral buildup. Might try a fuel additive to see if it will redude the buildup.
I am near Tusla Ok. I had a set of foam filled tires that were worn totally out and needed to replace them. I searched far and wide and found a commerical shop that foan filled tires. They cut the foam off for 25 a wheel. i was going to go back with regular air filled tires but then i went back...
Had the same problem with a 751, 1999 model, with Kubota engine. when first got it the trans light would come on. i had to let it warm up. i finally fixed it by changing the fluid and the filter. the machine was used and oil was old. Once i did those things it has worked like charm ever since. I...
After reading the replies I am little concern. first i didnot consider the compatiblity of material when came up with my first fix. so now i am concern the plug will leak or worse pop out when i am in the deep woods, .5 miles as the crow flies from the house. Second when the plug pop out the...
Thank you for your reply. it was my understanding that both plugs were the same size. when i went to install the new plug it was no where near a fit. i felt around the drain plug hole and it seemed to have a lip or extra thickness around the hole as if fit were made that way. i do not think it...
i have a 1999, 751 skid steer. the fuel tank has bushing or plug at the bottom to drain the tank. The chain case also has a bushing or plug to drain. Each is protected by a plate over the bottom to keep the plug from being knocked out by a stick or something on rough ground. My plate fell off...
I have Bobcat 751, made in 1999. I have notice the lower bushing on the tilt cylinder has a considerable amount of play. I just found out that the bushing can be relaced. my question is this: is the bushing pressed in or is it welded in. if it is pressed in can you drive it out with a hammer and...
what capcity floor jack would you need to raise the back of a 751 bobcat and what capcity jack stand would you need, the 751 is listed to weigh 4777 pounds.
Does anyone have experience with Trelleborg skid steer tires. as to how well they wear, puncutre resitance, poping off the rim. I will be using them in an agriculture setting as well with a tree shear to cut cedars? thanks in advance for your imput. I am thinking I need at least an 10 ply versus...
a few years back I purchased a Bobcat 751 used (1999 model) with tree shear. the shear was a vasser brand and could cut up to a 16 inche cedar and larger if i was willing to work around the base. i am in Oklahoma and there is real cedar problem therefore recieved a grant to clear my own land. i...
I have done more research and i think i can better explain what i need to know. Will a 12x16.5 tire mount on a 8.25x16.5 rim without any problems. based on what i have read a 12x16.5 tire normally mounts on 9.75x16.5 rim. i have a 751 which came with 8.25x16.5 rims and 10x16.5 tires. Thank you