Recent content by RDLDRDLD

Help Support SkidSteer Forum:

  1. R

    L218 Connector ECC1A Location

    We got this resolved.
  2. R

    2011 L218 codes 1203 and 3029

    While I was moving snow the skid started intermittently running at low RPMs. Now it will start and sputter around 100 to 400 RPM for a few seconds and quit. The 3029 code says the oil pressure sensor is shorted and I replaced it. The 1203 code is for RPM sensor. I heated everything up and...
  3. R

    L218 Connector ECC1A Location

    I am looking for the location of the ECC1A to ECC1B connector on an L218. A pic would be great
  4. R

    NH L218 Skid - Malfunction and Stop Light on cold start

    I found an error. It is low oil pressure. Prob nothing I can do about it except get it to a place I can plug the block heater in.
  5. R

    NH L218 Skid - Malfunction and Stop Light on cold start

    Today the temp was 9° F and the machine started right up, but I had the Electric System Malfunction light on solid, and the the STOP light Flashing. There was a 30 second timer running down at which point the machine shut down. I started it again, and the same situation. As the information was...
See more
Top