Recent content by punky

Juist picked up a craftsman strap wrench figured I would give that a whirl letcha know what I think of it

anyone recomend a good tool to remove the clutch adjustment cover nut on a modified M610 ?

Im not very computor savy I had to update my profile

For some reason Omachinist my darn machine will not let me email you keeps reading mail cliant........ my email is in my profile Thanks

machine tries to crawl forward on its own .

IS their supposed to be a locking brake or any type brake other than using your clutches?

This is the best forum that I have used you guys are a huge help. I had this machine given to me and the person who gave it to me was frustrated that he could not get it to run and when he gave it to me he said that the person he got it from did not know the model. Not knowing what I was up...

who should I order my manual from thats good quality ?

Thanks oldMachanist and going by the old historical specs the bucket could very well be from a M600E witch is 60” wide and and my bucket is 60 .5” wide I know that 25hp motor has alot of power possibly been modded I can tilt the bucket down to the virgin grownd and push till the buckets...

Or is their any id numbers that can confirm what gaalons per minute ?

Ok I measured the stroke on the lift cylinders and it came out to 25 and a little over three quarters inches and tilt cylinder stroke measured exactly 16.5 inches . how do I tell what the flow rate is on the pump?

thanks for that info is there any diference in clutches or gearing ?

problem is I dont know where they ar mesuring to get these numbers

I noticed something diferent when I visited your link 6brnoma to the historical specs and its called maximum reach are mostly all diferent mesurments the 600 has a different mesurment than the 610.

I am going to order a manual but not sure if it covers 610 and 600 if they are alike