Recent content by pete_rock

Here is a good video showing the new wire connector that I used to replaced the old original harness. http://www.te.com/usa-en/videos/transportation/deutsch-hdp20-hd30-te-logos.html I ended up replacing the two wire harness' under the cab and one near the motor. The hdp20 (i think the p stands...

Try to give B&W Supply a call at 863-537-6446. They are located in Florida. I got lucky and called about a Bobcat hour meter and got a real good deal, about 1/3 the cost of the dealer and it was a Genuine Bobcat Part. Pete

Try this link to the image. http://s11.postimg.org/68ituy55f/photo.jpg This is the original harness that failed. Note the male connector that broke off in female connector in top left pinout of wire connector. I'll take a picture tomorrow of the new harness that I wired up and send a photo. Pete

Hello. I also have a Bobcat 743 with a bad hour meter. These are the steps that I took to get it working: 1. Put 12 Volts DC across the leads of the hour meter and it began working. 2. Used a multimeter and tested positive connector (+) of hour meter and got 12 Volts. 3. Tested the negative side...