• Visit our tractor and agricultural equipment communities:
    Ingersoll Forum Case IH Forum Combine Forum Hay Forum
    JCB Forum John Deere Forum Kubota Forum Mahindra Forum
    Massey Ferguson Talk New Holland Forum Valtra Forum Yanmar Forum
    Zetor Forum Farming Forum

Recent content by pcmachine

Help Support SkidSteer Forum:

  1. P

    T190 starts and runs fine for 15 seconds then shuts down with code 5-15 but test gauge shows 300-350 psi charge pressure

    I traced the hydraulic pressure signal wiring from sender to ECU/controller and monitored the voltage at the ECU while starting and running the engine. Voltage varies directly with engine RPM and pressure reading on the test gauge installed on the manifold directly block under operators seat. I...
  2. P

    T190 starts and runs fine for 15 seconds then shuts down with code 5-15 but test gauge shows 300-350 psi charge pressure

    I'd like to verify the hydraulic pressure signal is getting to ECU/controller. Can anyone help me with the connector/pin number on the ECU that carries this signal from the pressure sender on the filter block?
  3. P

    T190 starts and runs fine for 15 seconds then shuts down with code 5-15 but test gauge shows 300-350 psi charge pressure

    T190 with 1800 hours starts immediately every time and runs "fine" for 10-15 seconds. Can lift, tilt, and drive forward/reverse with both tracks. During this the red hydraulic warning light is on and then flashing. Then engine shuts down with red hydraulic warning light staying on and code...
See more
Top