oiu789's latest activity

Lock and Lube makes the Grease Buster. You load it with penetrating oil put it on the zerk and hit it with a hammer. I rattle on mine...

Sounds like you might have air getting into the fuel system. Make sure bleeder valve is closed. Is the primer bulb soft or collapsed? It...

Did the glow plugs come out all intact? Ie tip not broke off. If the tip broke off it could be stuck in the valve. Do a compression test...

Perform a compression test on the engine to see if it is in spec. If you have 1 or more low cylinders pull the head and make sure all...

While it was sitting had it been raining? What shape is the exhaust system in? Was there a cover on it? What color is the water that...

Is the coolant level going down? Let it set for a few days crack the oil drain plug and note the color of what comes out does it match...

I won a Borroughs BT-33-73F belt tension gauge on HI Bid for 22.50 plus shipping that wasn't much. It is the same as the one that comes...

I use Baum Hydraulics Corp. 1221 Harney St, Omaha, NE 68102 Phone: (800) 228-9222

I use Baum Hydraulics Corp. 1221 Harney St, Omaha, NE 68102 Phone: (800) 228-9222

Did you check that the glow plugs are getting the right voltage to them? Check on how long they are energized. Could have a wiring or...

You should not be able to blow back into the tank as there is a check in the pickup or you should not hear bubbling in the tank if your...

Remove fuel cap remove line going in to primer bulb blow lightly in to line an listen do not use compressed air unless you use a...

Check all your hyd filters and strainers, cut them open. Could be plugging up causing pump cavitation low flow to the left side.

Try Googling skid steer parts. When I did it there are many places that sell new and used parts. They cost less than BC

Just jack up one side an try to rotate the front wheel back and forth and then the back wheel and since the free play in the chains...