Recent content by Novascotia632

Finally got the vane pump together and back in and from the looks of it I'll be sanding some end plates next. Its still doing the same thing. Thanks again for the vane Larry and yes you and Tazza were right. Will update again when I have the plates sanded and back in.

No worries, glad to help, Hotsy now owed by Karcher who also makes Shark came out with those disks a few years back and they caused alot of grief for alot of people. Most of the pressure relief valves on the market are only rated up to 150 deg. F, hotsy does not have a rating listed for theirs...

The previous owner told me he spent 4500 having the hydro pumps rebuilt so the guy who did the work should have his butt kicked. I'm hoping it is the vane because if not my next step looks like it would be tearing down the hydro pumps. All said and done I still don't know what is causing my...

Your coil does not raise the pressure, however if your burner does not shut off when you release your trigger gun the burner will super heat the water which will cause the rupture disk to blow. Do me a favour and fire your machine up, turn your burner switch on and pull then release your trigger...

Hi Larry I sent an email with my address Thanks again for your help

Yes you can remove the disk assy, plug the port hole and then install a pop off valve on the inlet side of your coil. Follow the hose that leads from your pump to your coil, there should be an inline tee at the coil with a threaded plug in it. Remove that plug and that is where your pop off will...

Since the posts on here have helped me I thought I'd offer my knowledge to help anyone with issues you may have or question about hot or cold pressure washers. I spent many years repairing and building washers and should be able to help. I don't sell any parts or units anymore but I still have...

Thanks lfutrell, This has been a hobby project that I almost wish I never started. I picked this unit up over a year ago off a beef farmer after beating him down for 1500, he said that he had the hydrostatic pump assembly rebuilt but was still having issues and since I always wanted a skidsteer...

First I would like to say thanks to all the members who wrote posts that I have scaned that helped me with getting this far with my bobcat 632 repairs. On that note I'm looking for one of the little vane plates for the hydraulic / charge pump. I have rebuilt both hydro drive motors, replaced...

I ordered a bronze filter for the port block on a 632 and the one that came in is longer and larger. The dealer said the original is no longer available and I'm required to purchase a new block and adapter. Does anyone know a way around this or where I can get the original size one. Thanks if...