Recent content by MDNMark

Kansas did you end up getting the new engine put in? If you did, did you end up having to lower the mount plate to get the pulley centered the in the same spot as the original? Did you have to cut anything out?

Thank you Tazza I believe my engine is a straight shaft but that is a good question. I’m going to have to make sure this weekend. Thank you for the link skidroe. I did look into the Briggs from small engine warehouse but I would still have to make a mounting plate and a few other things and it...

Thank you for the tips dynacore! Did you order a new pulley? My machine is the 1816b and I believe the Tecumseh oh160 had the 1-3/16” shaft? I think the predator is only 1” right? Did you shim the original pulley (the only shims I can find are 1” to 1-1/8”)or did you purchase an aftermarket? And...

Good morning everyone! I am new to this group. I recently purchased a case 1816b (for $200!) the skid has a tecumseh OH160 on it right now. I would like to throw on one of them predator engines on it (the tecumseh is on its way out and I can’t find parts). I was hoping someone in this group has...