Recent content by MAK

Actually I put it up for sale this past week. My property and the driveway I purchased it to maintain is just too steep more me to operate safely. I think even with the ROPS it would be a matter of time before I kill myself... I've used it half a dozen times since I got it and each time I scare...

Ouch. I was thinking my compression was good. Didn't realize it was supposed to be around 120. Not what I wanted to hear but I appreciate you checking on that and responding. Thanks

Looking for rollover protection for a Bobcat 610 in the North Georgia area. Thanks

The engine in the Bobcat 610 I just got is running rough. The #2 cylinder seems to be the source. When I remove the plug wire to that cylinder it seems to run smoothly... That plug was wet but otherwise looked new. That cylinder and two others have a compression of 90lbs. The #4 was about 85lbs...

That's what I needed to know. Figured I would probably have to weld up my own. Thanks for replies.

I may have found a source of a roll cage for my new 610 but it's an hour and a half away. Not sure the seller is able to get me the measurements... Does anyone know if a 753 cage will fit on the 610? I have no idea if they are even close to the same size and haven't found any details dimensions...

Hmmm, filled out all the location and profile info when registering but it apparently didn't populate in my settings. I'm in North Georgia so would be quite a drive from Arizona, but thanks anyway for the offer of help with the roll cage.

Thanks. I need to get somewhere that has some attachments so I can understand how these all hookup. Looking forward to playing with it this weekend to see how well I can smooth some ruts using the bucket. Does it have a sort of "free float" mode where if I lower the bucket to the ground that it...

Thanks for all the advice and insight. I planned on taking the slide panels off this weekend to have a look at the clutches, etc. Now I know to check and watch the sheave grease fitting. I figured I could fab up and weld together adapters or connectors if there wasn't a good and economical...

I just purchased an old Clark Bobcat 610 in what appears to be good condition with no cracks or broken welds, etc. Motor was running smooth and quiet with no odd noises, and all the controls worked with the rams going smoothly through their range of motion. Didn't see any leaks but I guess that...