Recent content by Lynn Perkins

My Hydro Mount is suppose to have 2 windows as per drawing. The CL 20 has an offset at the back for a smaller engine mount. Stock was an 2 cylinder Onan with female splines in the shaft end and cast iron pump bolt plate. There will be 24 " from the plate mount at front piston pump to where the...

OK, you just confirmed I would have difficulty connecting the chain coupling inside the Hydro Mount I have ordered. Is there is no master link to the chain on your machine? My next thought is try to locate set screw in either half sprocket and slide out over shafts. As soon as I get all the...

Hi, Don, Glad to hear from you. I finally got New Holland to look see if this coupling could still be purchased no luck. But I think I found a way around connecting the Wisconsin 1-3/8" straight shaft with the pump 7/8" 13 spline. Martin sprocket Half for 1-3/8" engine. Martin sprocket 1-1/2"...

I just joined after viewing pictures posted on the rebuild of the CL-30 by Don. I am getting together all the parts to install a 4 cylinder Wisconsin into one of my Ford CL20. My CL 20 has a 7/8" number 13 spine on the Hydrostatic pump and my Wisconsin has 1-3/8" straight shaft. I found a...