Id say putting both springs in there wouldnt hurt. They attach at the same places. Ive never seen only 1 spring...but I dont think Ive had the pleasure of working on the govenor of a 1502. :D
You could also have a brake going south. Best way is to jack the machine up and support it with the tracks free. Then hop in and run it at low rpm. If one track dosnt run or takes alot more force it could be the brake. The dealer is also just going to cap off your lines and then run it the same...
No that is the BICS lock. He asked for the SPOOL LOCK. There in one on each spool towards the front of the machine on the control valve. The BICS solenoid is a plastic sol. with 2 wires coming out of the side. It is held on by a cap with a 3/4 hex. It will be pointed towards the Left side of the...
Well they have to MOVE the same distance. If they move in different distances you will have differnt outputs on each of the hydrostats. That will make your machine turn to one side when you are driving it with both sticks all the way forward. Those 2 sets of 2 bolts and nuts i mentioned change...
Well the tracking could be off. You want to lift the cab (Engine off of course) and look at the bars going from the bellcranks to the pumps. When you move the sticks forward do they move the same amount or is one more forward then the other. I look where the 2 peice bars bolt together. Does it...
depending on the size when I was at bobcat they used alot of self tapping bolts on the covers on the newer machines. If its a 5/16" or a 3/8" they have plenty at the dealer and they arnt expensive. Ive also MADE self tapping bolts out of metric bolts that are just a bit bigger then the original...
Yea pretty much what Tazza said. Ive seen a bunch of old timers put ATF in there. Now just topping it off wont hurt anything but completely filling it up with it will. Im guessing you are saying a hole in the side of the ENGINE. Well...I hope you got it cheap because another engine is in your...
thats the ones...if that dosent work here is the link to an Ebay item. http://cgi.ebay.com/Bobcat-Backhoe-mounting-brackets-743-743B-753C-kit_W0QQitemZ190042390848QQihZ009QQcategoryZ66926QQssPageNameZWDVWQQrdZ1QQcmdZViewItem#ebayphotohosting
Usually if you are just doing dirt work its not cost effective. If you are doing alot of work like new home construction its a pretty good idea. Not alot of nails in the forrest. The MAJOR drawback to solids and tracks is they wear the chains, sprockets, and axles. Usually when a machine would...
The spool lock sol. for that machine are on the control valve towards the front of the machine. They will be inline with the linkage that goes to the Lift and tilt. They should have 1 black wire. A 1" wrench fits them and they are about 1.5" tall.