Recent content by KnightIRD

Okay, sorry for the long time. It turns on, runs for about 4 seconds, and it only runs on one cylinder. One cylinder is wet when we pull the plug out, and the other one is dry. What would cause this, and what would cause it to run in one cylinder? Any help is appreciated. Thanks!

Okay, ANOTHER problem. Go figure. We are getting ABSOLUTELY NO spark at all anymore, so how would I be able too check if the coil were bad? Any help would be GREATLY appreciated. Thanks! And if it would be anything else, im in for suggestions.

Oh. I just got word that it's the ignition switch. He held the key in the start position, and it ran for a good minute. So, we have to get a new ignition, and hopefully it'll work.

So... What do you suggest that I do now?

Okay, so the sparks LOOK blue. I have several pics and vids on my skydrive. IDK if these will help, but I hope they do! https://skydrive.live.com/redir?resid=65FDFEF61FEB5263!614&authkey=!AOLlYiXaoC4A14E Also, there is a guy in town, who is selling a Gehl 4500. IDK how much, but do you think...

Okay. So we JUST replaced the fuel, and the same thing. It runs a little better in those 5 secs now, but it's still doin the same thing. Also, do you know how to adjust the hydrostat drive control? Everytime it turns over, it wants too creep forward or backward. Thank

Okay, so we got that problem fixed. We didn;t have a wire hooked up right. But now, it turns over, starts, runs for about 5 secs and turns off again. I think it's probably the points. Anyone else think anything else of it? Thanks!

Hi. I have a Mitey Mac model 8B with an Onan engine in it. Replaced the flywheel, and starter, and now it won't turn over at all. No noise when the key is turned. The engine was out of the loader when we replaced the starter and flywheel. We put it back in, and it does NOTHING. There IS 12 volts...

Okay, So I got a new starter, and it worked for these 8 months. It was a cheap piece of crap on ebay. Today, it sounded like crap when I tried too start it. I took everything apart, and in the shroud in the flywheel, there was a HUGE piece of the coil. It covered the gear that controlled the...

OK, I suspected all of the remedies that you mentioned. I don't get any spark off of the spark plugs, and points. And, do you have a way of testing the distributor coil, because it won't start with jump or anything. The battery is fully charged, and it has 800 Cranking Amps. The starter is...

It cranks over, doesn't blow smoke, it's a gas, and the gas is fresh, and there is no spark at all. Also, my battery is good, but it barely turns over.

I have a Gehl Mitey Mac with an Onan NHC MS/3406C engine that won't start. I have no idea what it is. Please help me. I need to get this thing running again!