Recent content by KenJ

We used the Flaretite seal. We discovered that we needed to securely press that seal on to the male side before install. Working great. Thanks for your help.

Hey thanks everyone I'm ordering that seal now. I really appreciate your help on this.

Thanks We checked that closely and we can see it coming up from the fitting. But we'll check it again to make sure.

Thanks everyone, We used a new one of the ones on the right along with a new hose. I didn't think it would matter and our local suppliers didn't think so either. But we just can't get it to stop leaking. Is it possible to over tighten? I really don't want to introduce tape or dope into the...

Okay that link doesn't go anywhere here's the page and the picture, maybe I finally got this fixture:

Thanks for asking The machine is a 753 the fitting is #18 here...

Flat fitting between lift valve and hose that runs to pump it has 2 O rings on it. No exact factory replacement available.

Good morning In the photo below are the connector I took out of our 753 (left) and the replacement Bobcat sent us, and the only one they have available (right). This is the connector from the bottom of the Control Valve, BICS Combo Valve. Cant get the new one to seat with the hose connection...