You guys are correct. It was the vent hose for gas tank. I couldn't see it since it was facing the rear.
I checked the blower assem. and it was ok.
Thanks guys! now back to my shut down issue.
It has to be a sender or the boss unit.??? I will let you know what I find.
Could someone help me identify this hose? It is like a 3/4” heater type hose. It has a black plastic male end broke off in the end of it. You can see the hose clamp still attached. It takes off to behind the pump I cannot find where it is broke off from. I was hoping it wasn't sucking dirt in...
you know I have checked everything but that. I guess that should have been the 2nd or 3rd thing I checked not the last lol
Thats why I love this forum. Thanks Jimmy
Thanks guys, I will check it out. The only thing that concerned me was noticing the hydrolics to lift arms and bucket seemed sluggish right before the code would pop up?
Jimmy
I have a 1999 863 high flow. It has the dreaded BOSS system that has some led lights out in parts of the display. The machine has shut down 3 times in the past 2 months. The first time I noticed the hydro. running sluggish then a HF-? code popped up. I could not read the number because of the...
Could some one point me to some info on how to match my machine to the right tiller. Or if someone could share some widom with me I would appreciate it :)
Thanks Jimmy
Just wanted to let you know that I think I found the problem on the tac lock malfunction. It seemed the voltage regulator was defective and allowing the voltage to creep up to 17 to 18 volts. So, I guess the BICS was just doing it job and reporting the over voltage.
Thank you Tazza for your...
Thanks for your time and suggestions.
Could you tell me where the hydraulic lock solenoid would be? When the hydraulics lock would there be voltage to this lock solenoid or not?
Started it today. It started doing the same thing then just went away before I could dig in to it. I refaced all the...
Yes it does. would this coil lock the boom and tilt out also? Is this coil under the seat standing on end? When trac lock actually locks the boom, bucket and wheels from operating. What device is actually locking all of these at once? Being an electrician by trade the electrical system doesn't...
My trac loc keeps engaging. As I am running the machine the trac loc will engage, I look at the bics and all lights are flashing. I can't see where it is blinking a code they just all blink steady. Manual says under or over voltage to bics?
I have to shut the machine off restart it and hit the...
Yes, Water seeped in to the box and there is corrosion on the board. The corrosion started to eat a couple resistors on the board. It is only the bottom corner of the board. that the water effected. I will be making calls today trying to find one.
Jimmy