Recent content by JerryIke

I'm guessing I must, for 2 reasons. I replaced 2 hoses on the tilt yesterday. There is a lot of play in the bucket when trying to cut the ground level....the bucket will "push up" when running over a bump or rise in the ground. Also there is a leak from under the machine that I can't locate...

Ok with the tips from you guys I rebuilt 3 of the 4 cylinders and there are no leaks. Thanks to all!! Now how do I most effectively bleed the air out of them? My tilt especially compress while trying to dig and are almost creating more havoc then help!!

Gentlemen thank you for the hot water trick. I had been using a heat gun to get the seal pliable but the water worked so much better! I couldn't push the seal in with my fingers but after about 20 minutes and using a pair of needle nose without the serrations I was finally able to get it...

Hi guys. I'm trying to rebuild my tilt cylinder on an old Mustang 330. The problem I'm having is the inner seal that goes inside the screw on "end cap" for lack of better description. It's the one you fold into a "heart" shape and put inside the unit. It is suppose to unfold itself when inside...