Recent content by jcor

Would you happen to know what the hold voltage would be after open for the fuel solenoid?

I will give that a try. Not many options on electronics in a small town. I did a web search on (bobcat Diode) several hits, but no info on size or what they were for. Thanks for your time on this. If i get this figured out I will give an update.

I see it now in the schematic. Across 8100 (B wire power to the pull) and 2800 (C wire that is ground) on the fuel solenoid. It was hard to tell because it was broken and I'm no electronic wizard. How do I find out what diode to order? Local Bobcat is no help in my area.

I did replace the relays with new relays from Bobcat (Fuel pull, Starter) both the old ones did check good but replaced anyway. I know the resistor is bad because he broke it trying to jump around it and he was never able to make it work. I cant get any kind of number or ohm off of it. I know I...

I had ex bobcat mechanic come out and look at the machine. He put a different computer in to make sure all was good there and it was. Then he cut into wiring harness back further from the full shut off harness and exposed a resistor of some type soldered into the factory harness. I could not get...

I have a 2007 T320 that when you push the start button the starter engages for just a second and stops. I have to hit the stop button to try to start it again with same results. Replaced the relay but it was clicking every time I push the start button. The fuel shut off solenoid only opens for...