Recent content by Jay1835b

I have attached a picture of the wet oil valve guide tubes... can't see anything dripping or running actively out from anywhere exactly. Just gets wet like this after it's been running. I am going to clean it up and see if I can get a better sense of where it's stemming from but seems like where...

Thanks for the replies. The connection to the resistor was tight wasn't moving when I moved the wire. What did move was the tab coming out of the resistor. So I imagine the connection inside the block is broken. I have not taken it apart to verify. I found something that measured with a similar...

I believe I have narrowed it down to a bad ballast resistor for the coil. When i had it running i check the spark on all plugs. Everything looked good. Then moved around some wire by the coil and it stumbled. The qire from the harness to the reistor before the coil was stressed. Move the wire...

Hey all, Looking for some guidance. Recently picked up a 1985 Case 1835b gas engine skidsteer with 3300 hours and has been sitting for the last 9 years. It was used only 50 hours in the last 20 years. It seemed to start and run fine when I looked at it. Once I get it home it proceeds to shut...