Recent content by Hnowak

Yes, I have parts people in multiple GEHL and Manitou dealers searching for the part. No luck. I'm even trying to get my hands on the complete valve assembly, which costs $1000 for a $6.00 part.

Does anyone have or know where to get a 244518, or now it's called an N244518? It's the check valve on the 5-bank manifold where the pilot oil control solenoid and the main valve solenoids are located. Yes, I contacted all the typical parts warehouses, and it's not available.

I connected the gauges again and ran it all over the yard. I discovered that this failure occurs when I make a hard right turn. I went left so many times I got dizzy. When you turn hard right within seconds, it fails. A slow turn while moving right takes more time to fail. I think the psi relief...

I replaced the whole cartridge. I have the manuals for this unit. The original cartridge was moving inside the housing about 1/8 of an inch. I thought that was it, but it just runs longer before failure. I will be fully focused on it tomorrow and look for any valves I may have missed.

You are correct. There is no actual charge pump. The charge is sourced from the control valve and the hydro pump. I will check the block and see if there's trash or something. I don't recall the psi, but it was high enough that I was not concerned. I think I had a 600 psi gauge on it, and it...

Where would this valve be located? There is nothing on the filter itself or any additional lines coming off from it.

I found the charge psi drops off when it fails. I removed the solenoid and found it slipping in the housing. Put a new one in and ran it. It ran for 15 minutes, did the same thing. This time it immediately, fixes itself after a restart, then runs again for 10 minutes or so—same thing. I...

Has anyone had any issues with the hydraulic controls on a GEHL V330 just stop working, then when you restart the engine, all is good for about 10 minutes. It does this non-stop. A shop rebuilt the pumps but that wasn't the problem. When it stops working, the forward reverse controller will work...

I have a GEHL V330, and everything works fine for a few minutes. You can turn in either direction, drive forward or reverse; boom works in all directions. After a few minutes, the boom becomes very slow, and the machine will not turn at all. If you adjust the engine RPM, you can get it to turn...