Recent content by gtx71

mr. buckshot, instead of a new governor, could a rev. limiter be used. $900.00 is a hell of a lot of legal tender. tony b.

mr. ant. do you have any part # i would like to purchase locally. i.e. napa thanks, tony

hello, can anyone pass along part numbers of starter that will work on my bobcat 632 ford 4 cylinder thanks, tony b.

i removed the relief valve from the control block , replaced o-ring cleaned valve seems to be ok now . thanks for the help anyway tony

no i can actually remove quick connectors with no fluid loss

hello, i was experiencing drive issues that have since been corrected by removing and cleaning my bronze port filter (partially clogged). after i few minutes of working the machine i have lost up/ down and tilt of the bucket. i just went down to garage to try it again (cooled down) and still...

thanks in advance, not sure how to send my e-mail address to you though. tony b.

hello, can someone provide me with a repair manual for a bobcat 632, i have the manual for 741, 742, 743 743 ds not really sure of all the differences if any tony b easton, pa

i am in the process of rebuilding my control valve when i removed the hydraulic fittings, from control valve block i found 2@ orifice plates. and no springs behind them. can someone give some direction as to if there should be springs or not, and what direction the orifice plates go into the...

thanks for the help it is a bobcat 632 tony b.

can you pack the axle bearing with grease instead of filling the chain case the whole way. my axle tube are damaged seal o.d fit area and wondering why the bearing are flooded with oil versus grease packed thanks, tony

jerry, in and out thanks tony

hello, came across a used 632 and in the process of repairing the most obvious repairs, any ides of what could cause drive axle play to be over 1.00'' thanks, tony